Supported typesĮxample of a configuration in your configuration.yaml Notify Surveillance Center - forwarding the alert to a client application. This is useful to catch multiple quick trips in one window without the state toggling on and off. Hikvision/Ultimax DVRs belong to the newest generation of digital video. Specify the delay to wait after a sensor event ends before notifying Home Assistant in seconds. This platform also was confirmed to work with the following Hikvison-based NVRSĪdd the following lines are required in your configuration.yaml file: binary_sensor: This platform should work with all Hikvision cameras and nvrs,Īnd has been confirmed to work with the following models: Either Picture Quality or Picture Size can be set to specify the picture quality.
#Hikvision notify surveillance center software#
Click on Notify Surveillance Center (will send an exception or alarm signal to remote management software when an event occurs). If you configure an NVR with the name “Home” that supports 2 cameras withĬenter the following binary sensors will be added to Home Assistant: binary_motion_1 Check the checkbox to select the linkage method. When used with a NVR device the sensors will be appended with the channel number Motion detection and line crossing events enabled to notify the surveillanceĬenter the following binary sensors will be added to Home Assistant: binary_ont_porch_motion Note: Check the checkbox of Notify Surveillance Center if you want the alarm. Ensure this is applied on each individual camera in case of using an NVR.įor example, if you configure a camera with the name “Front Porch” that has wholly, by any means, without the prior written permission of Hikvision. the hikvision user must have the Remote: Notify Surveillance Center/Trigger. Ive set up email notifications in the Hikvision NVR, but it doesnt. I get only PIR notify surveillance center via hik-connect.
) only notify surveillance center via hik-connect wont work. (everything is working, recording, email notification.
#Hikvision notify surveillance center how to#
In order for the sensors to work the hikvision user must have the 'Remote: Notify Surveillance Center/Trigger Alarm Output' permission which can be enabled from the user management section of the web interface.Īlso the 'WEB Authentication' needs to be set to 'digest/basic' in the security/authentication section. Instructions on how to set up Hikvision camera binary sensors within Home. Hikvision GEN2 IP Intercom, 7 Touch Screen Room Station,WiFi,1024 x 600,12VDC/POE. In event center via push notification does not work Motion detection, Line crossing. The Security Center is a security platform which unifies IP licence plate recognition, video surveillance and access control in one single innovative and easy.
0 kommentar(er)
